TWO WAY COMPONENT SYSTEMSINSTALLATION & OPERATING MANUAL EINBAU- & BEDIENUNGSANLEITUNG
10 11Congratulations!On your purchase of the EMPHASER ECP-S6 2-way component system. If you plan on installing the ECP-S6 component system by yourself
10 11SET CONTENTUnpack the loudspeakers, crossovers and accessories and check if all parts are contained and undamaged, as listed below:• 2mid/woof
1213GENERAL INFO’S The first step of a successful install is to choose the best mounting locations for the tweeters and mid/woofers. Usually, cars com
1213FLAT SURFACE MOUNTINGDisassemble the angled surface mount adaptor.Mark and drill holes where you want to fix the tweeters. You can use the base ca
1415MID/WOOFER MOUNTING Remove the factory grilles of the front door and remove – if applicable – the factory installed full range speakers or mid/woo
1415Slide switch fortweeter attenuationWhen you tighten up the screws to mount the mid/woofers in place, be sure to check for an airtight seal and goo
16 17PUTTING INTO SERVICEAllow your component system to break in. During the first 20 to 50 hours of playback at medium listening levels, the mechanic
16 17 ECP210-S6 ECP213-S6 ECP216-S6Nominal Size 4" (10 cm) 5 ¼" (13 cm) 6 ½" (16.5 cm)Configuration/System 2-Way 2-Way 2-WayNo
18 19WARRANTY CONDITIONSKeep the original packing and the sales receipt for warranty purposes and read the warranty limi-tations further down below. E
18 19WARRANTY CARD / GARANTIEKARTETYPE OF SET: ❏ ECP210-S6 ❏ ECP213-S6 ❏ ECP216-S6Date of purchase:Your name:Your address:City:State:
2 3INHALTTechnische Merkmale...3Lieferumfang...
Emphaser Inc., Wyoming, Michigan, U.S.A.
2 3TECHNISCHE MERKMALETIEFMITTELTÖNER 10 cm / 13 cm / 16.5 cm Tiefmitteltöner mit Euro-DIN Korb Strontium-Ferrit Magnet Fiberglas Membrane Butylgu
45GENERELLE INFO’S Der erste Schritt einer erfolgreichen Installation ist, die akustisch optimalen Einbauplätze aus-zuwählen. Berücksichtigen Sie für
45AUFBAUMONTAGE DES HOCHTÖNERSDer Hochtöner für Aufbaumontage besteht aus zwei Kunststoff Adapterschalen und der eigentlichen Hochtöner-Systemeinheit.
67ANSCHLUSS DER FREQUENZWEICHENDie Frequenzweichen können in einem vorhandenen Hohlraum in der Türe, an der Türverkleidung selber, oder auch in den Se
67Abb.: Schiebeschalter für HochtonabsenkungBefestigen Sie nun die Tiefmitteltöner in den Lautsprecheröffnungen. Achten Sie auf einen perfekt dichten
8 9INBETRIEBNAHMEDas Komponentensystem sollte zum Erreichen der vollen Klangqualität einige Zeit einspielen, es erreicht erst nach etwa 20 bis 50 Stun
8 9 ECP210-S6 ECP213-S6 ECP216-S6Nenndurchmesser 4" (10 cm) 5 ¼" (13 cm) 6 ½" (16.5 cm)System 2-Weg 2-Weg 2-WegNennbelastbarke
Comments to this Manuals